Describe the feature or hardware support you'd like
I found that the default probe points setting for "resonance_tester" is -1,-1,-1 for the adxl345_BTT_SB22xx file pointing to the adxl345_software_spi.cfg
#probe_points: -1,-1,-1
paths:
config/hardware/accelerometers/adxl345_BTT_SB22xx.cfg]
config/hardware/accelerometers/generics/adxl345_software_spi.cfg
I was unable to find any default override to this setting based on printer dimensions selection in the printer.cfg or anywhere else. By having the probe points set to negative values, the calibration fails on input shaper due to the points being out of range.
My feature request is to add a note to the printer.cfg or overrides.cfg reminding to set the resonance tester probe points based on bed size OR to streamline the probe points into a setting like printer dimensions.
As an example, I set my resonance tester probe points to 175,175, 50 since my bed is a 350, 350 and I wanted it 50mm higher than the bed.
Additional context or information
No response
Describe the feature or hardware support you'd like
I found that the default probe points setting for "resonance_tester" is -1,-1,-1 for the adxl345_BTT_SB22xx file pointing to the adxl345_software_spi.cfg
#probe_points: -1,-1,-1
paths:
config/hardware/accelerometers/adxl345_BTT_SB22xx.cfg]
config/hardware/accelerometers/generics/adxl345_software_spi.cfg
I was unable to find any default override to this setting based on printer dimensions selection in the printer.cfg or anywhere else. By having the probe points set to negative values, the calibration fails on input shaper due to the points being out of range.
My feature request is to add a note to the printer.cfg or overrides.cfg reminding to set the resonance tester probe points based on bed size OR to streamline the probe points into a setting like printer dimensions.
As an example, I set my resonance tester probe points to 175,175, 50 since my bed is a 350, 350 and I wanted it 50mm higher than the bed.
Additional context or information
No response